Fortanix Data Security Manager - Sysadmin Settings - Interfaces

Introduction

This article describes the interface settings that are configured by the System Administrator. The settings configured here are applicable to every object of the entire cluster.

Interfaces

When you set up a cluster, the interface on which the Fortanix Data Security Manager (DSM) runs, will be configured. Request client certificate is the endpoint that is used when you want the app to authenticate using certificates. It is the mutual TLS for certificate-based authentication. If you select the check box corresponding to Request client certificate, Fortanix DSM will request the client certificate on that interface.

By default, only one interface is enabled. If you use multiple interfaces, you can change the default interface by selecting the corresponding radio button as shown below:

Interfaces_Dialog_Box.PNG

Figure 1: Interfaces

Redirect Feature

You can access the URL selected as default as shown in the previous section. Enable the Redirect toggle for the Host URL(s) to always redirect to the default URL on the screen.
For example,
As shown in the following figure, the default Host URL is sit.smartkey.io and the Redirect toggle is enabled for api .sit.smartkey.io. So, whenever you access the latter URL, you will always be redirected to the former URL, which is set as the default.

Redirect_Feature.PNG

Figure 2: Redirect Feature

Comments

Please sign in to leave a comment.

Was this article helpful?
0 out of 0 found this helpful